Torch stalling no reason?

Discussion in 'CNC Cutting' started by GarageNerd, Jan 10, 2018.

  1. GarageNerd

    GarageNerd Active Member

    Joined:
    Nov 15, 2017
    Messages:
    40
    Likes Received:
    2
    Trophy Points:
    43
    No errors anywhere. Hit stop and run again it works fine. Has happened a few times.

    Again, sorry for all the posts, new equipment jitters and bugs.

     
  2. OcalaWill

    OcalaWill Well-Known Member

    Joined:
    Jun 22, 2016
    Messages:
    205
    Likes Received:
    37
    Trophy Points:
    78
    Compressor large enough?
     
  3. GarageNerd

    GarageNerd Active Member

    Joined:
    Nov 15, 2017
    Messages:
    40
    Likes Received:
    2
    Trophy Points:
    43
    Yep, more than enough. It shuts off in jobs as it pumps more than is used.

    Also, no low gas warning on plasma.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice