Finally allowed to do business again and the pc isnt powering on. I ran a job, it sat then I went back out and it had disconnected from accumove. Shut it down, no life when I hit the power button. Edit: the power cord is good, it works on another pc Any ideas?
Same here! Just turned on flexcut, powerd up the Accumove and walked to the export the design when I came back to do my DATUM and insert the USB I noticed the screen was still off. I checked all my connections and everything looks good. It just seems like the PC is not booting up! Did you contact Lincoln (Torchmate)? Any troubleshooting steps?
