Re-registering my vmd

Discussion in 'CNC Cutting' started by Darren, Nov 4, 2019.

  1. Darren

    Darren Member

    Joined:
    Aug 3, 2016
    Messages:
    14
    Likes Received:
    3
    Trophy Points:
    68
    I have been running my table the last 3 years off a laptop. I went and switched it out with a PC, when I installed the vmd driver software it prompted try order or register. I don't know what or where to find these. Apparently I have 21 days to resolve this or I'm gonna be dead in the water... Any help would be greatly appreciated!! TIA
     
  2. Darren

    Darren Member

    Joined:
    Aug 3, 2016
    Messages:
    14
    Likes Received:
    3
    Trophy Points:
    68
    All I really need to know is where to look to find these numbers.. thanks again!
     
  3. Dnmeistr-LECS

    Dnmeistr-LECS Moderator Staff Member

    Joined:
    Dec 22, 2015
    Messages:
    684
    Likes Received:
    109
    Trophy Points:
    123
    I believe the registration screen says call or contact Torchmate for unlock code, did you do so. If not send email to support@torchmate.com with the 8 digit code, found on the same screen that asks you to register or try the software.
     
  4. Darren

    Darren Member

    Joined:
    Aug 3, 2016
    Messages:
    14
    Likes Received:
    3
    Trophy Points:
    68
    Thank you very much! I will give that a shot! I didn't know if it was something that came with the machine, or if I had to call.. lol
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice