program wont move

Discussion in 'CNC Cutting' started by andrew mcbride, Jun 26, 2020.

  1. andrew mcbride

    andrew mcbride New Member

    Joined:
    Jun 18, 2020
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    I upload a program and when I do a dry run, it will go through it just fine. When I do an active run, the torch will come down and touch off, start an arch, and then just sit there and not move, with the arch going. Am I missing something???
     
  2. LECS-Chad

    LECS-Chad Moderator Staff Member

    Joined:
    Dec 15, 2015
    Messages:
    655
    Likes Received:
    189
    Trophy Points:
    123
    This is a OK TO MOVE issue. The controller/software is looking for the OK TO MOVE signal and not getting it.

    This can be either a configuration, wiring, or FAUTL condition.

    More details are needed. Machine, software, plasma cutter.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice