nesting

Discussion in 'CNC Cutting' started by Kchoghead, Mar 9, 2021.

  1. Kchoghead

    Kchoghead Well-Known Member

    Joined:
    Jan 19, 2016
    Messages:
    223
    Likes Received:
    32
    Trophy Points:
    108
    when nesting in cad 9 the software goes into time and then locks up and then cad software closes. any help would be appreciated
     
  2. Kchoghead

    Kchoghead Well-Known Member

    Joined:
    Jan 19, 2016
    Messages:
    223
    Likes Received:
    32
    Trophy Points:
    108
    here is the file
     

    Attached Files:

  3. xardion

    xardion New Member

    Joined:
    Jul 3, 2019
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    16
    I just imported the DXF and nested the tree with no problems (though I am using v8 not v9). The only issue I have run in to while nesting is including tool paths. If I nest with tool paths it crashes, so now I just nest all my parts (ensuring proper spacing in the nesting setup) and the create toolpaths after it has been nested.
     
  4. Kchoghead

    Kchoghead Well-Known Member

    Joined:
    Jan 19, 2016
    Messages:
    223
    Likes Received:
    32
    Trophy Points:
    108
    Thanks.. I will try that
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice