MATCHING CORRECT SOFTWARE VERSION WITH SIGNAL GENERATOR DRIVER

Discussion in 'CNC Cutting' started by Justweldbaby, May 8, 2021.

  1. Justweldbaby

    Justweldbaby New Member

    Joined:
    Jun 20, 2017
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    66
    I recently purchased an older 2x2 Torchmate. It looks to be in decent shape. No software or paperwork was included. Being that I have some basic experience using a Torchmate w/ Accumove 3 at work, I believed I could make my recent purchase work.
    My first problem is I am not sure which version of software to download for my 501A signal generator/Driver. Serial Number #220319. Is it Version 3 or Version 4 ?Will downloading the wrong version damage my Driver ?
    When I did download version 4 I was unable to connect to Signal generator. I figure this was a good place to stop and reach out for help. Any suggestions would be highly apreciated.
     
  2. LECS Hunter

    LECS Hunter Administrator

    Joined:
    Feb 10, 2021
    Messages:
    22
    Likes Received:
    1
    Trophy Points:
    3
    Hello, thank you for reaching out on the forum. If you find it hard to get a response from the community, there are other resources you can try.
    Here is a Facebook group you may find helpful. https://www.facebook.com/groups/170485276316053/about
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice