Search results

Sorry, Completely forgot that I had this account. The students were able to construct the design on AutoCAD and made a 2D as well as a 3D model of it before starting the build. We were able to tour "Yoder Smokers" in Yoder,KS and had a few design concepts from them, but as far as measurements...

Here is a project that 2 of my Senior students started building this Fall. All of this came from the idea of having a "Backyard smoker" and decided why not. It was their last project to build in the shop and wanted to go all out. Luckily we were able to use donated metal, fundraising, and a...

We purchased our table 5 months ago as a "Ready Pak", Have not had much issues except for recently when we run our programs mainly in the bottom left corner and every so often the table will jam in the middle of the cut and stop. after trying to restart the machine, it gives me an "invalid...

Quick question for the Torchmate Veterans out there, I have a 4x4 growth series table and wanted to replace the water, hooked up to the drain in the back corner, but only water from that "section" drains any suggestions before I waste my time?

I have tried it both ways, I will try and screw the cap out a little bit and see if that works

I just went and checked my machine and have the correct Shield on the machine, I have also been able to eliminate the little Ohmic tab because it moves out when I install the shield, which in my mind tells me that it is at least making contact.

Hi Everyone, Hopefully someone can help me, We are Nickerson High School, a small 4A in central Kansas. Our school recently bought a torchmate 4x4 Accumove 2 and having a little trouble. Until recently everything has been working perfectly.... or so I thought, The table has been "jamming"...