I have yet another issue with a Lincoln product, the flexcut 80 torch head and consumables. Just when i think this equipment is running properly I...
I spent a day last week on the phone with and engineer running over some of the basic test. There were a few bugs that we worked out in those test...
Larry, I haven't seen anything like you mention. What I have seen/heard is one of the motors binding. Its not repeatable completely ramdom....
Chad, I would love nothing more than to call and speak with someone. Each time I have called tech support there have been long wait times, and I...
So contacted TM when this occurred and we went a few steps and everything checked out as it should have. So a 2nd table with more of the same...
We finally got our replacement torchmate 4800 last Monday. We ran into a few problems... Namely the torch pins. 2 were bent and one was broke...
Update.... El Jefe was able to get our table shipped out yesterday and the arrival is scheduled for 8-10am Monday, 10.3.16.
El Jefe, Thanks for that update as i'll be sure to look for that video when the new machine arrives. Also when did this change take place as our...
"A video of this test unique to each table is now included on the hard drive of the system as proof of the test cut." Where would this be...
I agree with everything above. Lincoln is standing by their product and getting this fixed for us properly. I just got off the phone with a...
No penetration from cut example last night... [ATTACH]
Bottom example was from last night before it stop penetrating. Top example was from this morning as the gantry was jerking about. [ATTACH]
More issues at start up? Anyone else ever had these issues? Would a torch head cause the accumove to lose its position? Do you turn everything off...
[ATTACH] This morning we start the machine and the datum position is way off. X-5.... nothing has changed since last night. The condition of this...
Separate names with a comma.
