Recent content by MKS

My table has limit switches. The quick start you linked is the one I've been using.

I understand these are on the AVHC box but there is no signal generator and no machine interface for plasma and no place to plug another plug in. On the back of the CNC controller left to right the power cable uses the same connector as a computer, a voltage selector, two pin input goes to start...

The manual that came with the unit shows a separate signal generator and motor drive box but I have a single unit very similar to the compact CNC controller on page 16 of the October 2013 Quick start cutting with AVHC. On the back of the CNC controller there is a similar plug with six wire...

we are going to reinstall the driver software on our computer but found we do not have the disk is that something we can download or buy?

There no wires to the pierce terminal only Torch, OK to move and Start. When the controller is on there is a green and amber light on. is the amber light the input status indicator? Just to clarify we have the blue AVHC box and the compact (one piece) controller. I jump torch and it starts...

Before the torch fires the OK to move circuit is open, as soon as the torch fires the circuit closes. So am I correct in assuming that the computer sends the start signal through the motor controller to the AVHC then the AVHC upon receiving the OK to move signal sends a start program request...

Yes dry run works.Yes we checked all wires and AVHC box is good to go.I will check the links you provided and hope to find somthing we missed

Our table is seven years old and have the exact same problem plasma head moves to start location pierces and wont move time out code comes up.Any other ideas?